Want to read Slashdot from your mobile device? Point it at m.slashdot.org and keep reading!

 



Forgot your password?
typodupeerror
Check out the new SourceForge HTML5 internet speed test! No Flash necessary and runs on all devices. ×

Submission + - Arts & Crafts

James-NSC writes: I like to do arts and crafts. I’ve been saving up motherboards for a while as a new medium and I started working on it last night. I wore the same gear I wear while painting – fine particulate respirator and safety goggles. I just cut some templates out of some motherboards and when I was done I used the shop-vac to clean myself & workspace up before removing my mask. Even after 5+ minutes, in a well ventilated area (not as well as it should have been apparently) my first breath was pins and needles. I’m looking into containment and exhaust solutions – ala baby’s first iron lung, but seriously, am I nuts? Are these materials just too toxic to work with?
This discussion was created for logged-in users only, but now has been archived. No new comments can be posted.

Arts & Crafts

Comments Filter:

I have a very small mind and must live with it. -- E. Dijkstra

Working...