Forgot your password?
typodupeerror
Hardware Science Technology

Printing a Building 112

Posted by Soulskill
from the you're-gonna-need-a-bigger-boat dept.
RedEaredSlider writes "Researchers at the Massachusetts Institute of Technology are trying to push 3-D printing technology even further. Their goals: create whole working machines and perhaps even buildings. Thus far, 3D printing has been used to make shapes of plastic or metal that can be assembled later. These folks want to change that. One idea is to use concrete in a novel way: 'Not only would it be possible to create fanciful, organic-looking shapes that would be difficult or impossible using molds, but the technique could also allow the properties of the concrete itself to vary continuously, producing structures that are both lighter and stronger than conventional concrete. To illustrate this, Keating uses the example of a palm tree compared to a typical structural column. In a concrete column, the properties of the material are constant, resulting in a very heavy structure. But a palm tree’s trunk varies: denser at the outside and lighter toward the center. As part of his thesis research, he has already made sections of concrete with the same kind of variations of density.'"
This discussion has been archived. No new comments can be posted.

Printing a Building

Comments Filter:

Passwords are implemented as a result of insecurity.

Working...